A "Charley Bar" is a very useful device to improve
security when installing a pet door in a sliding glass door. It
installs behind the sliding glass door and locks the slider against
the pet door.
Adjustment range is 17 1/2" -
31"
$1949 19PO01
Charley Bar
This adhesive backed foam weather-strip is
used along the edge of panel pet doors to provide a weather-tight
seal between the pet door and the jamb or sliding glass door. Many
other uses around the home as well. This is the standard weather
strip included with the Thermo Panel IIIe and the Quick Fit! III.
$899
12PM01
5/8"
wide x 3/8"
thick x 17' long
Adhesive-Backed Foam Weather-strip
Patio Door Pin Locks lock your sliding glass
door against the pet door. This allows you to install the pet doors
as 'temporary' as well as 'semi-permanent' (fastened in place with
sheet metal screws).
$289 30SH06
Patio Door Pin Lock
Universal Bug Seal fastens to the edge of the
sliding screen door and points inward. The rubber edge effectively
seals the gap up to 1 1/4"
between the pet door and the screen thus closing the 'bug gap'. Thin
rubber strips may be pealed off the edge to make it more narrow if
needed.
Remember that the panel may be
thinner than your door so you can't really measure the gap until you
install the panel.
Available in bronze (very dark brown) or satin
(aluminum color).
$2095-Satin
$2695-Bronze
12CR01
84"
Universal Bug Seal
$2795-Satin
$3395-Bronze
12CR02
96"
Patio Pacific 'Draft Stopper' will work with
any brand panel pet door for sliding glass door. Also known as
'Center Post Weather Strip', its purpose is to seal the gap created
between stationary and sliding glass doors when a panel pet door is
installed. These are essential for an air-tight fit. Some customers
use two--one at each end of the gap--for an even better seal. Trim
to fit with scissors. Adhesive is 1/2"
wide and begins inset 1/8"
. Overall width is 17/8".
.jpg){kind=small}
.gif)
.jpg)
