CATHOLE INSTALLATION INSTRUCTIONS
1. Before removing door, mark desired position for unit on
bottom of door (Figure 1).
2. Remove door by pulling hinge pins. Hint: position
flat screwdriver to catch top of pin and tap upward with
hammer.
3. Use supplied "Door Hole Template" to trace entrance
hole outline (Figure 2). 4. Use
Jigsaw to carefully cut entrance hole.
5. Measure thickness of your door and select correct
screws. Note: if door is 13/8" thick, use (3) short
(black) screws.
if door is 13/4" thick, use (3) long
(silver) screws.
6. Insert (3) screws Into front of Frame A (Figure 3).
Insert (4) pins into back of Frame B (Figure 3).
Hint: one end of pin has a chamfer is tapered. This end
will insert much easier.
7. Align frames on opposite sides of door and gently
tighten screws (Figure 4).
Note: do not tighten any
screw completely... tighten each screw a few turns and
move to the next. Continue until frames are snug on both
sides.
8. Fold brush and insert middle of brush into top of
frame opening. Press brush into place so that tabs on
back of brush rest on lower screws (Figure 5).
9. Press wooden plugs into countersunk screw holes and
apply desired finish. There are many attractive ways to
decorate your CATHOLE. ..CATHOLE can be pointed or
stained. ..Colorful decals or stencil patterns can be
applied...Water based polyacrylics are durable & easy to
use. 10. Reinstall door and let
kitty enjoy!
 | 
